Skip to content
English
  • There are no suggestions because the search field is empty.

Changing your two-factor methods and recovery codes

Add a second two-factor method, remove one you no longer use, or replace your recovery codes from My Profile.

Add a second two-factor method, remove one you no longer use, or replace your recovery codes from My Profile.

This is for anyone who already has two-factor authentication turned on. If you have not set it up yet, start with Setting up two-factor authentication. Everything here is on the Two-factor authentication card: open the menu under your avatar, select Settings, then My Profile. The card lists each method you have, with your email address partly hidden next to the email method.

Adding another method

Select Add another method and follow the steps in Setting up two-factor authentication for the method you choose. The button appears only if your organisation allows a method you do not already have. Recruit shows a recovery codes screen again at the end, so save what it shows.

Removing a method

  1. Select Remove next to the method.
  2. In the Remove verification method window, enter a current code in Verification or recovery code. For an authenticator app, that is the code the app shows. For email, select Email me a code and enter the code sent to you. A recovery code also works, but using one removes all of your methods, not only this one.
  3. Select Remove. The button is available once you have typed at least six characters.

Removing your last method switches two-factor authentication off, and the card shows "Two-factor authentication has been disabled." You can set it up again whenever you like.

If the code is refused you see "Invalid code. Please try again." Too many wrong attempts show "Too many attempts. Please wait a few minutes and try again."

When you cannot remove a method

  • If your administrator requires two-factor authentication for the whole organisation, there is no Remove button and the card says "Two-factor authentication is required by your organisation."
  • If you are a System Admin, HR or Group Admin user, you can remove a method only while you have another one. Your last method cannot be removed, and entering a recovery code does not get around this.

Replacing your recovery codes

Select Regenerate recovery codes and confirm with Regenerate. Recruit immediately creates a new set and shows it. Every earlier code stops working, so save the new set before you close the window, using the same steps as at setup: Copy all or Download codes, then tick I have saved my recovery codes and select Done. Do this if you have used most of your codes or think someone has seen them.

Changing your password

With two-factor authentication on, changing your password also asks for a code. Enter it in Authentication code and select Verify and change password. Changing a password signs you out on every device and ends any trusted devices, so every browser asks for a code at the next sign-in.