Skip to content
English
  • There are no suggestions because the search field is empty.

Choosing where candidate replies go

Decide whether replies reach the person who sent the email, a shared mailbox or each candidate's record.

Decide whether replies reach the person who sent the email, a shared mailbox or each candidate's record.

This is for System Admins, the only people who can open the page in Settings under the Custom Sending Domain card. The reply-to address decides where a candidate's reply lands when they press reply. It is separate from the sending domain and works whether or not a domain is verified. If your account belongs to a group of companies, choose the company in the selector beside the page title first.

How Recruit picks the reply address

Recruit uses the first of these that applies:

  1. The address a user chose in the Reply-To field when writing a message themselves. It must belong to an active user in your organisation, otherwise Recruit rejects it with "From address must belong to an active user in your organisation".
  2. The email address of the user who sent the email, if Send replies to the person who sent the email is on in the Sender section. It is on by default.
  3. The address in Default reply-to address in the Reply-To Address section.
  4. An automatic reply address for that candidate, so their answer is attached to their record in Recruit.
  5. The email address of the job's owner.

Choose a setup

To have recruiters receive replies personally, leave Send replies to the person who sent the email on.

To collect all replies in one place:

  1. Open Settings then Custom Sending Domain.
  2. Turn Send replies to the person who sent the email off.
  3. Enter a shared mailbox such as careers@yourcompany.com in Default reply-to address.
  4. Select Save at the top right.

Clear Default reply-to address and save to remove it. If the switch is off and the field is empty, replies use the automatic per-candidate address.

When a user writes a message themselves

In the email composer the field is labelled Reply-To, with the hint "Reply-to address (defaults to organisation sender)". It must be a valid email address. If it is not, sending is blocked with "The Reply-To address is not a valid email address". An address that is valid but does not belong to an active user in your organisation is rejected with the message in the first item above.

Problems you might hit

  • "Could not save email settings. Please try again." Check that the default reply-to address is a valid email address.
  • Replies are going to the wrong person. Check the order above. A Reply-To address typed into the composer beats everything else, and the sender switch beats the default address.
  • Replies arrive in Recruit and not in a mailbox. The automatic per-candidate address is in use, which happens when the switch is off and no default address is saved.

Related articles