Skip to content
English
  • There are no suggestions because the search field is empty.

Entering a verification code when you sign in

What the two-factor step looks like at sign-in, how to use an authenticator app, an emailed code or a recovery code, and how to trust a device.

What the two-factor step looks like at sign-in, how to use an authenticator app, an emailed code or a recovery code, and how to trust a device.

This article is for anyone who has two-factor authentication on their account and has just entered their password. Two-factor authentication is required for Admin, HR and Group Admin users, and for everyone if your organisation has made it compulsory. Setting it up, adding a second method and replacing recovery codes are covered in Setting up two-factor authentication.

The code step

Recruit asks for a second step after your password is accepted. What you see depends on the methods you have set up.

  • Authenticator app only: you go straight to the Two-factor authentication screen. Type the 6-digit code from your app into Authentication code. Recruit submits it as soon as the sixth digit is in, though you can also select Verify.
  • Email code set up: you first see How would you like to verify? Select Use my authenticator app (only shown if you also have one) or Email me a code. The address it will use is shown underneath, partly hidden. Nothing is sent until you select the button.

Your password has already been accepted by the time you reach this screen, so if the code step fails you do not need to change it.

Using an emailed code

After you choose email, the screen says "We emailed a 6-digit code to" your address. Enter the code in Authentication code. The box has this label for emailed codes as well as app codes.

An emailed code expires after 5 minutes. If it has not arrived, or it has run out, select Send a new code. If the email cannot be sent you see "We could not send your code. Please try again."

Using a recovery code

If you cannot reach your app or your inbox, select Use a recovery code, type one of the codes you saved during setup (format XXXXX-XXXXX) into Recovery code and select Verify. Each recovery code works once. Recovery codes are not submitted automatically, so you always need to select Verify. Select Use a verification code to switch back. Back to login takes you to the first step.

Trust this device for 30 days

Under the code box, on the authenticator and emailed code screens, there is a tick box called Trust this device for 30 days. It is unticked by default. Tick it before you select Verify and that browser skips the second step the next time you sign in with your password, for up to 30 days. You still enter your password every time. The tick box is not shown on the recovery code screen, because signing in with a recovery code never makes a device trusted.

Trust ends early when you change your password, when an administrator ends your sessions or resets your two-factor authentication, when you change, turn off or set up two-factor authentication again, or when your account is deactivated. You are then asked for a code again, and you can tick the box again to trust the browser afresh. Use it only on a device that nobody else uses. This is a separate choice from Keep me signed in for 30 days, which controls how long your sign-in lasts, not whether a code is asked for.

If the code is refused

  • "Invalid code. Please try again." The code was wrong or has timed out. The box clears. Enter a new code, or select Send a new code if you are using email.
  • "Your session has expired. Please log in again." The code step took too long. Recruit returns you to the login page after about two seconds. Start again.
  • "Verification failed. Please try again." The code could not be checked. Try again, or use a recovery code.

If you have lost both your app and your recovery codes, an administrator can reset your two-factor authentication. Troubleshooting sign-in and access problems covers who to ask.