Tagging candidates and setting up custom flags
How to add, remove and filter tags on candidates, and how custom flags and sensitive flags work.
How to add, remove and filter tags on candidates, and how custom flags and sensitive flags work.
Tags sit on the candidate, so they are shared across every job the candidate has applied for. Anyone who can open a candidate can tag them. Setting up custom flags, which turn a tag into an icon, is for System Admin and HR.
Add tags to many candidates
- On the Candidates page, select the candidates.
- Open Manage and choose Add Tags.
- Type the tags in Tags, separated by commas, for example: strong prospect, nightshift cover.
- Select Add Tags. The button stays disabled until you have entered at least one tag.
Tags are added to what the candidate already has, and repeats are ignored. Each tag can be up to 100 characters, you can add up to 50 in one go, and a candidate can hold 200 in total. A candidate who would go over 200 fails. Tags are matched exactly, so "Senior" and "senior" are two different tags. You see "Tags added to candidates." or, if some failed, "N succeeded, N failed" followed by the names of those not processed.
Remove or edit one candidate's tags
Bulk removal is not possible. Open the candidate and select the tag icon (Edit tags) next to their name. Ticked tags are the ones they carry. Select a ticked tag to remove it, or type a new one in the custom tag box and select Add (or press Enter). Changes save immediately.
Bulk Add Tags treats every comma as a separator, so it cannot create a tag such as "Relocating, needs visa". Add that tag from the candidate's own tag editor, which keeps it as one tag. The tag filter treats it as one tag as well.
Filter by tag
On the Candidates page, open the Tags drop-down, search if needed, and tick one or more tags. The list shows candidates who carry any of the ticked tags. The filter applies to the Active and Talent Pool tabs alike, and it clears your selection. Tags appear in the Tags column of the table. A brand new tag can take a few minutes to appear in the list of tags to filter by.
Custom flags
A Custom Flag turns a tag into a small icon that shows on candidates in a job's Pipeline tab, so hiring teams spot something important at a glance. Up to four icons show on a candidate, then a "+N" badge; hover to see the names. Only System Admin and HR see flag icons.
System Admin and HR set flags up under Settings, Job Setup, Custom Flags. Select Add Flag and complete:
- Name, shown when someone hovers over the icon, and an icon.
- Candidate tag: lowercase letters, digits and underscores only, for example disability_confident. The flag shows on every candidate who carries exactly this tag, however it was added.
- Optionally, an Application form question with Question text and a Trigger answer. When a candidate submits the application form on your careers page with that answer, the tag is added automatically.
Deleting a flag does not remove the tag from candidates. They keep the tag, but it no longer displays as a flag.
Flags and scheme icons for Admin and HR only
When you create or edit a flag, you can tick Visible to Admin and HR only. The help text reads "Hiring managers and other users will not see candidates' tags that match this flag. Use for disability or reasonable-adjustment flags." The flag's card then shows an Admin and HR only badge. Other roles do not see those tags on candidates, in the Tags column, in tag filters, in search or in tag suggestions, and a filter on a tag they cannot see matches nobody.
A sensitive flag cannot be deleted or have its tag changed until it is unmarked: "Un-mark this flag as sensitive and save before changing its tag or deleting it." Unmarking makes existing tags visible again.
The same page has a UK inclusion schemes card. Each scheme (Disability Confident scheme, Armed Forces Covenant and Care Leaver Friendly) has its own switch labelled Visible to Admin and HR only. Switch one on and other roles no longer see that scheme's icon. Only an Admin can change it.